The roof tiles
All small roofing materials are overlapped. Moreover, there are two types of overlap:
- single overlap, the result of which is a single layer of roofing. This type of overlap is formed grooving tape or stamped tiles when each tile has grooves and the fold (crest), allowing it to cling to adjacent tile;
- double overlap is used for flat tile, and slate and wood tiles (i.e., flat piece of material). When double overlap is formed two-layer and even triple-layer roofing as videolounge numbers block niiauaieyie more than half the length of the shingles.
It should be remembered that a single overlap of the weight of the roof is less than double.
To the sheathing shingles fastened with nails, staples, cleats, wire sludge by its own weight.
Flat tiles are usually nailed or fastened with clips. The capping is fixed once two tiles. Horizontal lapel capping rests on top of an already attached shingles, and vertical lapel is supplied adjacent tile. Kamernye hooks hammered into the crate from the attic. Kamernye top flaps are closed upstream tiled around.
Wire attach all shingles located at the overhangs (eaves and gable), on the edges and the ridge. Prikamskie and gable tiles can be attached with staples of a special configuration. On the slopes with a slope of 35 degrees ordinary shingles is not usually mounted wire. On roofs with a slope of 35-45 degrees, or are located in regions with strong winds the shingles are tied through one number. When slopes greater than 45 degree wire attach each tile.
On roofs, where the rays have a slope of about 60 degrees, and grooving stamped tiles not attached to the crate, and fits freely and is held by its own weight and a special interlocking design.
The tiled roof has zigzag pattern like a brick wall when the joint 2 tiles fisherspooner number of falls in the middle of the tile below. To achieve this, all the odd-numbered rows begin and end with whole tiles, and all even - half-hearted.
The laying direction of the tiles from the bottom up (from the eaves to the ridge) and from right to left (for grooved tiles) or from any of the pediment (for flat tiles).
The laying is carried out in 3-4 rows at the same time and is as follows: in prikordonna row lay two whole tiles; in the second - first half of the shingles, and then the whole; the third row shows one whole tile. Then back to the first row and put another tile in all the already started series (the first, second and third). In the fourth row, attach one half and one whole shingles in the fifth and one whole - and we're back to the first row to add one whole tile laid in all the ranks, etc.
In order that the load on the support structure of the roof was uniform, it is desirable to conduct roofing work simultaneously on both ramps.
On completion of laying the tiles after 3-4 months transverse joints, it is recommended to fluff from the attic with lime mortar with the addition of fibrous materials (hemp, cleavers), and on top to paint over oil paint.